Télécharger Imprimer la page

Westfire WF35 Notice D'installation Et D'utilisation page 8

Publicité

UK
WESTFIRE UNIQ 35
Model choice
Closed combustion
STOVE PERFORMANCE & TESTING
Westfire Uniq 35 models have been approved in accordance with EN 13240.
Stove model
UNIQ 35 standard
UNIQ 35 pedestal
PREPARATORY WORK AND SAFETY CHECKS – IMPORTANT WARNING
IMPORTANT WARNING
This stove must not be installed into a chimney that serves any other heating appliance.
There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to emit fumes
into the room.
Chimney – Chimney Connection
Flue Diameter 125mm
In order for the stove to perform satisfactorily the chimney height must be sufficient to ensure an adequate
draught so as to clear the products of combustion and prevent smoke problems into the room.
Flue gas flow rate wood /coal
UNIQ 35 4.6/ 4.7g/sec
NOTE: A chimney height of not less than 4.5 metres measured vertically from the outlet of the stove to the top of
the chimney should be satisfactory. Alternatively the calculation procedure given in BS 5854:1980 may be used as
the basis for deciding whether a particular chimney design will provide sufficient draught.
The outlet from the chimney should be above the roof of the building in accordance with the provisions of Build-
ing Regulations Approved Document J.
If installation is into an existing chimney then it must be sound and have no cracks or other faults which might
allow fumes into the house. Older properties, especially, may have chimney faults or the cross section may be too
large i.e. more than 160 mm x 160 mm. Remedial action should be taken, if required, seeking expert advice. If
it is found necessary to line the chimney then a flue liner suitable for solid fuel must be used in accordance with
Building Regulations Approved Document J.
Any existing chimney must be clear of obstruction and have been swept clean immediately before installation of
the stove. If the stove is fitted in place of an open fire then the chimney should be swept one month after instal-
lation to clear any soot falls which may have occurred due to the difference in combustion between the stove and
the open fire.
WESTFIRE · WF35
UNIQ 35 Standard
UNIQ 35 PEDESTAL
50mm base
Yes
Efficiency
Weight
Wood/coal
78%/76%
80kg
78%/76%
110kg
Test flue gas temperature wood /coal
259/240c
400mm pedestal
3 sided frame
Yes
Nominal heat output
Wood
Smokeless fuels
4.6 KW
3.7 KW
4.6 KW
3.7 KW
8
UNIQ 35 Inset
4 sided frame
Yes
Yes
CO@ 13% 02
Wood/coal
.12/.17
.12/.17
@ pascals of pressure
12

Publicité

loading