Publicité
The first lighting of your stove
The heat-resistant paint on your stove will cure and harden the first time you light your appliance. The curing
process produces a good deal of smoke and odour, it is therefore important that the first time you light your
stove the room should be well ventilated. During the process it is important to open and close the stove door
periodically (every 30mins) during the first couple of firings therefore preventing the door seal cord around the
door from sticking and coming away from the door. Once the heat-resistant paint has hardened the smell will
disappear. This stove is NOT designed to be used with the door open, the stove door must be kept closed except
when lighting the stove, adding firewood or removing ash in order to prevent flue gases from escaping. Door not
operate appliance with ash pan removed or open.
Lighting your appliance
Quality Firelighters should be used when lighting the stove. (Never use mentholated spirit, petrol or other
flammable liquids). Lighting your stove with firelighters will be more reliable and easier than using paper.
UNIQ 35 RELOAD WEIGHTS
WOOD (HARDWOOD LOGS)
SMOKLESS COAL BRIQUETTES (REGISTERED ONLY)
To light your stove Wood
1. Place a few smaller pieces of dry wood (kindling) in the stove on top of the nontoxic firelighters, place one or
two small dry split (¼ split) logs on top.
2. Fully open the secondary air control above the stove door on right hand side. Fully open primary air control at
base left of stove. Pull out riddling arm fully at base right of stove (if necessary). The Uniq 35 stoves air controls
are now fully open.
3. Light the firelighters and push door to closed position and close handle to 1st position; this will allow a small
gap in the door for more air to be supplied to stove during ignition period.
4. When the flames are established and the fire is burning brightly push the door latch to position 2 fully closed.
5. Once fire is burning brightly again close the primary air control. Push in riddling arm. This will close off the
primary air to the stove. If the stove begins to falter after the primary is closed, open primary control again and
leave until fire has established, then close.
6. The fire should now be fully established and burning brightly. At this stage close secondary air control by 50%,
this is the operational setting. For the stove to burn cleanly and efficiently plenty of secondary air is needed,
do not be tempted to shut the fire down too early as this may cause smoke. At nominal heat output, expect to
refuel your stove once an hour.
The WESTFIRE UNIQ 35 stove is equipped with a manual regulating control for secondary air; this is designed to
ensure a plentiful supply of oxygen during firing. It is important therefore to not fully close the secondary air
control.
When lit, the stove will get very hot and due care must therefore be exercised. Please use a glove and operating
tool supplied when operating air controls and riddler.
RE-FUELING wood
To re-fuel your stove in the cleanest way.
Only refuel your stove when flames have died down and you have glowing embers.
WESTFIRE · WF35
1 HR RELOAD
1.2kg
N/A
13
2 HOUR RELOAD
1,2kg
1.1kg
UK
Publicité
