Publicité
Les langues disponibles
Les langues disponibles
03. On the NEW transmitter, press the same key pressed in
point 01 once and then release.
Alternative procedure
01. On the NEW transmitter, press and hold the key *** for at
least 3 seconds and then release.
02. On the OLD transmitter, press and hold the key *** for at
least 3 seconds and then release.
03. On the NEW transmitter, press the same key pressed in
point 01 for at least 3 seconds and then release.
04. On the OLD transmitter, press the same key pressed in
point 02 for at least 3 seconds.
5.3 - PROGRAMMING A TIMER
"Timer 1" and "Timer 2" represent the time in which the relays
remain active:
– Timer 1 used for relay 1. This timer corresponds to the work
time of relays 1 and 2, when programmed with Function 9,
11 or 13.
– Timer 2 used for relay 3. This timer corresponds to the work
time of relays 3 and 4, when programmed with Function 10,
12 or 14.
The factory settings of the two Timers is 120 seconds. This
value can be modified by means of the following "self-learn-
ing" procedure.
01. If the relay is active, deactivate with the relative command;
02. set dip switch 1 to ON (fig. 3-L) to program Timer 1 or
dip switch 2 (fig. 3-M) for Timer 2: the led next to the dip
switch illuminates to indicate activation of the program-
ming phase;
03. according to the selected timer, activate the required
relay by means of the relative key: the time count is
then started immediately;
04. when the required time has elapsed, press the key again
to deactivate the relay. The time elapsed has been mem-
orised and will be applied as the new timer value;
05. return the dip switch to OFF: the led next to the dip
switch turns off and the receiver returns to normal operat-
ing status.
5.4 - DELETING THE MEMORY
• Total memory deletion
To delete the entire memory of the receiver, or alternatively
only the memorised transmitters, proceed as follows:
01. Press and hold the receiver key and check the sequence
of the green Led status:
after approx. 4 seconds, the led illuminates
after approx. 4 seconds, the led turns off
after approx. 4 seconds, the led starts flashing...
02. Then:
– to delete all memorised transmitters, release the receiv-
er key on precisely the third flash of the led;
– to delete the entire memory (including transmitter
configurations and encoding family) release the key on
preci sely the fifth flash of the led.
This function can be performed also using the programming
unit Obox or Oview.
• Deleting a single transmitter from the memory
To delete a single transmitter from the receiver memory, pro-
ceed as follows:
EN
9
Publicité
