Blades Replacement; Blades Dimension; Rubber Ball Replacement - battioni Pagani WPT Série Notice D'emploi Et D'entretien

Figure 14

10.3.2 - BLADES REPLACEMENT

1. Check that there is sufficient space at the back of the Rotary blades vacuum pump to be able to work easily; if there is not,
the Rotary blades vacuum pump should be taken off its support beforehand;
2. Remove the back;
3. Extract the blades from the rotor;
4. Clean the Rotary blades vacuum pump;
5. Replace the blades and the gaskets and the oil seals of the rear flange;
6. Re-fit the back of the Rotary blades vacuum pump.
7. Use only Battioni Pagani
®
Request the Rotary blades pump revision kit containing in a single blister pack: Original Battioni Pagani
blades, gaskets and oil seals.

10.3.3 - BLADES DIMENSION

NUMBER OF
MODEL
BLADES
WPT 480 6
WPT 600 6
WPT 720 6
KTS 840 6
KTS 960 6
KTS 1080 6
KPS 490 5
Table 9
IMPORTANT: Make sure that the blades received for replacement are of less or equal length to the
nominal size shown in Table 9.

10.4 - RUBBER BALL REPLACEMENT

1. Unscrew and lift the valve holder lid (WPT and KTS series)
2. Replace the rubber ball;
3. Close the valve holder lid (WPT and KTS series)
for WPT, KTS, KPS, KTM, WSM series use and maintenance
e original spare parts
BLADES SIZE
300x73x7,5
400x73x7,5
500x73x7,5
500x80x6,7
570x80x6,7
640x80x6,7
460x60x6,5
NUMBER OF
MODEL
BLADES
KPS 550 5
KPS 670 5
KTM 1200 6
KTM 1500 6
KTM 1800 6
KTM 2300 6
WSM 2700 6
WSM 3300 6
Instruction Manual
®
BLADES SIZE
410x82,5x7,5
500x82,5x7,5
529x98x7,5
639x98x7,5
555x125x7,5
650x125x7,5
678x128x7,5
828x128x7,5
pag. 63