Operation; Heat And Blower Levels - SilverCrest SHC 2000 A1 Mode D'emploi

WARNING! RISK OF PERSONAL INJURY!
Do not cover the air intake grill while operating the appli-
►
ance. Clean the grill at regular intervals.
The hair dryer becomes hot when it is in use. Hold it only by
►
the grip when it is hot.

Operation

NOTICE
► Before using the appliance for the first time, run it at the highest heat and
blower level for approx. 2 minutes (see "Heat and blower levels"). This re-
moves manufacturing residue on the heating elements inside the appliance.

Heat and blower levels

1) Insert the plug into a power socket.
2) Switch the hair dryer on with the blower level switch 4.
The hair dryer is fitted with two function switches. With these you can separately
select the strength of the air flow (blower level switch 4) and the level of heat
(heat level switch 5):
Blower levels
0
Heat levels
3) After use, switch the appliance off in that you place the blower level switch 4
into position "0". Then remove the plug from the wall socket.
■ 6 │ GB │ IE
The hair dryer is switched off
reduced air flow
full power air flow
low heating level
medium heat level
high heating level
SHC 2000 A1