Preparation; Operation; Heating And Blower Levels - SilverCrest SHTT 2200 B1 Mode D'emploi

Preparation

1) Remove all parts of the appliance and the operating instructions from the carton.
2) Remove all packaging material.

Operation

This appliance is fitted with a contact sensor. This means that the hairdryer
only switches on if you are holding it in your hand and touching the sensor
field

Heating and blower levels

1) Insert the plug into the mains power socket.
The hairdryer is fitted with two function switches. You can use these to separately
select the strength of the air flow (blower level switch 6) and the heat level (heat
level switch 7):
Blower levels
0 hairdryer is switched off
reduced airflow
increased airflow
Heat levels
reduced heat level
medium heat level
high heat level
2) Select the desired blower level using the blower level switch 6. The control
lamp 5 illuminates and shows that the hairdryer will start as soon as the sen-
sor field
3) Select the desired heating level using the heating level switch 7.
4) If you are not holding the hairdryer in the hand:
take hold of the hairdryer with your hand on its handle. This means that you
will be touching the sensor field
If you put the hairdryer down for a short time, it will switch off automatically.
■ 18 │ GB │ IE
3 at the same time.
3 is contacted.
3 and the hairdryer will switch on.
SHTT 2200 B1