Publicité
Les langues disponibles
Les langues disponibles
W 95
Spray Material
Thinner-soluble varnishes/ primers
Water-soluble varnishes / primers
Automobile spray paint
Wood preservatives, disinfectants, plant protectants,
polishes, strippers, oils
Hammer effect enamel
Aluminium paints
Measuring the Viscosity
Dip the viscosity test cup (Illus. 1) completely into the spray material. Hold the test cup
up and measure the time (in seconds) until the liquid empties out. Compare the measu-
red "runout time" with the Viscosity Table.
Start-up
1. Before connecting to the mains supply, please be sure that the supply voltage is
identical with the value given on the rating plate (on the side of the spray gun).
2. Dilute the spray material according to the above table.
3. Place the container on a sheet of paper and fill it with the prepared spray material.
Attention! Do not operate the spray gun without spray
material in the container.
4. Position the spray gun on the container and turn the container to the right until the
container fits tightly (Illus. 2, arrow).
5. Activate the switch to start up the spray gun.
6. By turning the fine adjustment button you can vary the spray amount (Illus.3,arrow).
Spray Technique
● Cover areas that are not to be sprayed. When woriking keep in mind that wind, for
example, may transport paint mist over great distances and cause damage.
●
Do not spray the vessel empty. The suction tube should always be immersed in liquid.
If air is sucked in, larger drops may result.
● Test the spray gun on cardboard or a similar surface to find the correct setting.
● When spraying, hold the spray gun in a horizontal position. Use the flexible nozzle
extension (Illus. 7, arrow, special accessories) for spraying upwards (e.g. a
ceiling)or downwards (e.g. an unhinged door laid on the floor).
Handling Table for Viscosity
Viskosity: (Runout time in seconds)
20-35
20-50
18-22
undiluted
25-35
20-30
GB
20-45
20-60
18-22
30-45
20-30
13
Publicité
