HQ Power LEDA03C Notice D'emploi page 4

unprofessional use of the device.
• All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong
their lives.
• Use the original packaging if the device is to be transported.
• Keep this manual for future reference.
4. Features
• auto-, sound-, DMX or master / slave mode
• 18 preset colours + 6 built-in programs with or without DMX
• sound activation possible via DMX mode
• connection possibility for up to 12 x LEDA03 (not incl.)
• indoor use only
5. Overview
Refer to the illustrations on page 2 of this manual.
A ON/OFF-switch
Menu button
Enter button
B
Up ( ) button
Down ( ) button
Hardware setup
1 External DMX controller
2 LEDA03C
3 linking cable
6. Hardware installation
Refer to the illustrations on page 2 of this manual.
• The LEDA03C can be used stand alone or in combination with other LEDA03Cs. Note that each
LEDA03C requires its own power supply (mains outlet).
• A LEDA03C can control up to 12 LED-lamps (LEDA03, not incl.) via the RJ45 output [D].
a) Mounting
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other
applicable norms.
• Install the device in a location with few passers-by and inaccessible to unauthorised persons.
• Have a qualified electrician carry out the electrical connection.
• Make sure there is no flammable material within a 50cm radius of the device Make sure the
ventilation openings are clear at all times.
• Connect one or more (max. 12) LEDA03s to the output port. Refer to the illustration on page 2
of this manual and to the user manual that comes with the LEDA03 for more information.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
11/12/2009
LEDA03C
Note: [1], [3], [4], [5], [6] and [7] not included. [2], 1x included.
4
C display
D output port (RJ45)
E DMX input
F DMX output
G power cord
4 splitter
5 LED lamp
6 DMX cable
7 DMX terminator
[3] + [4] + [5] = LEDA03
©Velleman nv