HQ Power LEDA03C Notice D'emploi page 5

• The installation has to be approved by an expert before the device is taken into service.
b) DMX-512 connection
Refer to the illustrations on page 2 of this manual.
• When applicable, connect an XLR cable to the female 3-pin XLR output of a controller ([1], not
incl.) and the other side to the male 3-pin XLR input [E] of the LEDA03C. Multiple LEDA03Cs
can be linked through serial linking. The linking cable should be a dual core, screened cable with
XLR input and output connectors.
• A DMX terminator is recommended for installations where the DMX cable has to run a long
distance or is in an electrically noisy environment (e.g. discos). The terminator prevents
corruption of the digital control signal by electrical noise. The DMX terminator is simply an XLR
plug with a 120Ω resistor between pins 2 and 3, which is then plugged into the XLR output
socket [F] of the last device in the chain.
7. Operation
Refer to the illustrations on page 2 of this manual.
• The LEDA03C can work in 3 modes: automatic (pre-programmed), sound controlled or DMX-
controlled.
• Make sure all connections are properly made and plug the power cord [G] into a suitable mains
outlet.
• Switch on the LEDA03C with the ON/OFF-switch [A]. The system will start up in the same
mode it was in when it was switched off.
• Use the control buttons [B] to configure the device.
Note: press and hold the control buttons for faster setting.
a) menu overview
b) auto mode
• In this mode, you can select one of the 18 preset static colours or 3 build-in programs to run the
whole system
• Press the menu button and press the up- or down button until the display [C] shows
• Press the enter button and use the up- or down button to select the desired output:
11/12/2009
fixed colours: static red to static gold
...
change colours in steps
cross fade colours
strobe light
LEDA03C
5
.
©Velleman nv