HQ Power LEDA03C Notice D'emploi page 7

e) slave mode
• In slave mode, the LEDA03C will respond according to the control signals it receives on the
DMX input [E] and forwards these signals on its output [F]. This way multiple devices can run
synchronously.
• Press the menu button and press the up- or down button until the display [C] shows
Note: the first LEDA03C in the DMX-chain can not be set to slave. It can run an internal program
or can be connected to an external DMX controller (not incl.). The last LEDA03C in the chain
must have a terminator installed to avoid DMX signal corruption.
f) manual mode
• In manual mode, you can set the red, green and blue LED outputs individually, thus creating
your own output colour.
• Press the menu button and press the up- or down button until the display [C] shows
• Press the enter button and use the up- or down button to select a LED. Press the up- or down
button to set the intensity (0 = off, 255 = full brightness):
8. Technical specifications
power supply
power consumption
data output
dimensions
weight
ambient temperature
Use this device with original accessories only. Velleman nv cannot be held responsible
in the event of damage or injury resulted from (incorrect) use of this device. For more
info concerning this product, please visit our website www.hqpower.eu. The information
in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written consent of the copyright
holder.
11/12/2009
LEDA03C
230VAC ~ 50Hz
max. 36W
RJ45
125 x 70 x 194mm
1.65kg
max. 45°C
7
red
green
blue
.
.
©Velleman nv