Demounting Tube-Type Tires; Mounting Tube-Type Tires - Accu-Turn ACCU 3602 Manuel De L'opérateur

5.0 DEMOUNTING TUBE-TYPE
TIRES
A. For breaking the bead operate as described for the
tubeless tires in @ 4.1.A to 4.1.F.
In this case the valve is part of the tube.
WARNING!
BE CAREFUL NOT TO DAMAGE THE TUBE DURING THE
BEAD-BREAKING OPERATION.
THE VALVE SHOULD BE OPPOSITE TO THE BLADE OF THE
BEAD BREAKER.
B. To demount the first bead, place the valve at 2
o'clock position.
WARNING!
DO NOT CATCH THE TUBE WITH THE BEAD LIFTING TOOL,
WHEN LIFTING THE BEAD ON THE MOUNTING FINGER.
After demounting the first bead remove the tube
before demounting the second bead, as described in
@ 4.1.

5.1 MOUNTING TUBE-TYPE TIRES

A. Do as described in @ 4.2.A.
Do NOT lubricate the tube. Talc can be used to assist
with tire positioning.
B. Confirm that the tube is designed for tires(Fig.25).
(Fig.25)
14
C. Inflate the tube slightly: if held with the indexfinger it
should bend a little (Fig.26).
(Fig.26)
D. Mount the first bead as described @ 4.2 (B.).
Put the tube inside the tire and hang the valve with
the clip of the inflating hose (Fig.27).
Mount the top bead following the directions above.
(Fig.27)
341
Operator's Manual
342
343
ACCU 3602