Installation; Operation; Control Panel; Making Ice - Polar Refrigeration T316 Mode D'emploi

Telephone Helpline: 0845 146 2887

Installation

Note: If the appliance has been stored in a non-vertical position, stand it in an upright
position for approximately 12 hours before operation. If in doubt allow to stand.
Remove the appliance from the packaging and remove the protective film from all surfaces.
1.
Remove the Scoop, Inlet/Outlet hoses and Sealing Washers from the ice bin.
2.
When positioning the ice maker, maintain a distance of 20cm
3.
(7 inches) between the appliance and walls or other objects for
ventilation. Increase this distance if the obstacle is a heat source.
If necessary, adjust the screw legs of the ice maker to make it
4.
level. The efficiency of the ice maker can be reduced if the
appliance is unevenly located.
Connect one end of the corrugated outlet hose to the water outlet
5.
on the rear of the ice maker.
Attach the other end of the hose to a plumbed-in stand waste pipe
6.
or container suitable for collecting waste water.
Place the sealing washers on the water inlet at the back of the ice
7.
maker and attach one end of the inlet hose.
Connect the other end of the inlet hose to the water supply.
8.
Note: Ensure the end of the drainage pipe is situated lower than the Water Outlet valve
for efficient drainage.

Operation

Control Panel

Power switch

Making Ice

Note: Before using for the first time (or after a period of inactivity), clean the water tank,
ice basket and ice basket shelf. Use the first ice making cycle to flush out the system.
Discard the water and ice created from the first cycle.
Press the Power switch to the On position [I]. The RUN light illuminates and the appliance begins the
1.
ice making process. Each ice making cycle takes approximately 25 minutes.
When the cubes reach the ice sensor ice production stops. Production resumes once ice has been
2.
removed from the bin.
Press the Power switch to the Off position [O] at any time to halt the ice making process.
3.
I
O
RUN
Water
inlet
Water
outlet
FAULT ICE WATER
FULL LOW
UK
Power cord
2