Safety Tips; Introduction; Pack Contents; Installation - Polar Refrigeration T315 Mode D'emploi

Masquer les pouces Voir aussi pour T315:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
UK

Safety Tips

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components or service panels on this product.
Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
DO NOT immerse in water, or use steam/jet washers to clean the unit.
DO NOT cover the appliance when it is operating.
Always carry, store and handle the appliance in a vertical position.
Replace any unused water in the tank at least once every 24 hours.
For indoor use only.
Keep all packaging away from children. Dispose of packaging in accordance to the regulations of local
authorities.
If the power cord is damaged, it must be replaced by an POLAR agent or a recommended qualified
technician in order to avoid a hazard.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your POLAR product.

Pack Contents

The following is included:
Ice Maker
Removable ice basket
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

Installation

Note: If the appliance has been stored or carried in a non-vertical position, stand it in
an upright position for approximately 12 hours before operation.
Remove the appliance from the packaging and remove the protective film from all surfaces.
1.
When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and
2.
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
If necessary, adjust the screw legs of the appliance to make it level. The efficiency of the appliance
3.
can be reduced if it is unevenly located.
1
Ice scoop
Instruction manual

Publicité

Table des Matières
loading

Table des Matières