Inlet Box - Briggs & Stratton UL 1008 Manuel D'installation Et D'utilisation

Inlet Box

Installation must strictly comply with all applicable
federal, state and local codes when installing the
generator inlet box provided with this system.
1. Locate and mount inlet box on an outside wall as
close as possible to transfer switch. However,
consider household air intake ducting when when
locating generator and inlet box.
A typical transfer switch complete installation is
depicted in Figure 5.
2. Remove inlet box inner panel. Mount inlet box on
an outside wall (Figure 6).
3. Run appropriately sized conduit from transfer
switch to inlet box. Anchor all boxes, conduit, and
fittings.
Figure 5 — A Typical Completed Transfer Switch Installation
INSTALLATION
Transfer
Switch
Main
Distribution
Panel
Figure 6 — Inlet Box Installation
Inlet Box
11