Basic Operation - Sharp AY-XP7HR Mode D'emploi

BASIC OPERATION

DISPLAY
MODE
1h
CLEAN
FAN
SET/C
TIPS ABOUT AUTO MODE
In the AUTO mode, the temperature setting
and mode are automatically selected accord-
ing to the room temperature and outdoor
temperature when the unit is turned on.
Modes and Temperature Settings
0 10 18
Cool
(24°C)
29
Dry
Heat Heat
(24°C) (23°C) (
Room Temp.
21
indoor temp.
(°C)
The fi gures in ( ) are temperature settings
During operation, if the outdoor temperature
changes, the temperature settings will auto-
matically slide as shown in the chart.
MODE CHANGEOVER
During seasons when you need COOLING
at daytime and HEATING at night, or if the
room temperature should become extremely
higher than the temperature setting, due to
supplementary heating equipment, the mode
will automatically switch between HEAT and
COOL mode to keep the comfortable room
temperature.
2
5
3
1
4
outdoor
28 34 temp. (°C)
Cool Cool
(25°C) (26°C)
)
-2°C
Heat
(22°C)
1
Press the MODE button to select the
operation mode.
AUTO HEAT
2
Press the ON/OFF button to start
operation.
• The red OPERATION lamp (
will light.
3
Press the THERMOSTAT button to set the
desired temperature.
AUTO/DRY MODE
• The temperature can be changed in 1°C incre-
ments within the range of 2°C higher to 2°C
lower from the temperature automatically deter-
mined by the air conditioner.
COOL/HEAT MODE
• The temperature can be set within the range
of 18 to 32°C.
4
Press the FAN button to set the desired
fan speed.
AUTO SOFT
• In the DRY mode, the fan speed is preset to
AUTO and cannot be changed.
5
To turn off the unit, press the ON/OFF
button again.
• The red OPERATION lamp (
will turn off.
E-6
COOL DRY
) on the unit
(Example: 1°C higher)
C
(Example: 2°C lower)
C
LOW HIGH
) on the unit