Setting Air Purifying Filter; Tips On Saving Energy; Auxiliary Mode - Sharp AY-XP7HR Mode D'emploi

SETTING AIR PURIFYING
FILTER
The air purifying fi lters are packed as accessory
o f t h i s u n i t . D u r i n g o p e r a t i o n o f t h e a i r
conditioner, the fi lters remove dust and tobacco
smoke from the air and discharges clean air.
1
Take out the air fi lters.
1 Open the open panel.
2 Push the air fi lters up slightly to unlock them.
3 Pull the air fi lters down to remove them.
1
2
2
Set the air purifying fi lter under the fi lter
stoppers located on the air fi lter.
Air purifying fi lter
Air fi lter
3
Reinstall the air fi lters.
1 Reinstall the air fi lters in the original posi-
tions.
2 Close the open panel.
3 Push the arrow-marked of the panel fi rmly to
lock it in place.
3
2
1
Precautions:
• The fi lters are sealed in a plastic bag to keep their
dust collection effect.
Do not open the bag until using the filters.
(Otherwise the fi lters life may get shorter.)
• Do not expose the filters to direct sunlight.
(Otherwise they may deteriorate.)
3
Filter stopper

TIPS ON SAVING ENERGY

Below are some simple ways to save energy when
you use your air conditioner.
SET THE CORRECT TEMPERATURE
• Setting the thermostat 1°C higher than the desired
temperature in the COOL mode and 2°C lower in
the HEAT mode will save approximately 10 percent
in power consumption.
• Setting the temperature lower than necessary
during cooling operation will result in increased
power consumption.
BLOCK DIRECT SUNLIGHT AND PREVENT
DRAFTS
• Blocking direct sunlight during cooling operation will
reduce power consumption.
• Close the windows and doors during cooling and
heating operations.
SET PROPER AIR FLOW DIRECTION TO OBTAIN
THE BEST AIR CIRCULATION
KEEP FILTER CLEAN TO ENSURE THE MOST
EFFICIENT OPERATION
MAKE MOST OF THE TIMER OFF FUNCTION
DISCONNECT THE POWER CORD WHEN THE
UNIT IS NOT USED FOR AN EXTENDED PERIOD
OF TIME
• The indoor unit still consumes a small amount of
power when it is not operating.

AUXILIARY MODE

Use this mode when the remote control is not
available.
TO TURN ON
Lift the open panel of the indoor unit and press
the AUX. button.
• The red OPERATION lamp (
light and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are set to
AUTO.
TO TURN OFF
Press the AUX. button again.
• The red OPERATION lamp (
turn off.
NOTE:
• If the AUX. button is pressed during normal
operation, the unit will turn off.
E-5
) on the unit will
) on the unit will
AUX