Basic Operation - Sharp AY-XM7CR Notice D'utilisation

BASIC OPERATION

AM
DISPLAY
FULL
POWER
MODE
1h
FAN
CLEAN
SWING
SET/C
The PLASMACLUSTER and the
SELF CLEAN buttons are provided
only on models AY-XPM7CR/AY-
XPM9CR/AY-XPM12CR.
NOTES:
This air conditioner is a multi-type, and two (or three) indoor units are connected to one outdoor unit.
When the setting mode differs among indoor unit(s), the indoor unit(s) operated later may not work.
• When the indoor unit(s) is/are operating in HEAT mode, the remaining unit(s) can not operate in
COOL or DRY mode.
• When the indoor unit(s) is/are operating in COOL or DRY mode, the remaining unit(s) can not
operate in HEAT mode.
When the mode of the indoor unit(s) later operated is/are different from those which is/are in
operation, 4 seconds later, a long BEEP will be emitted and the temperature indicator on the
indicator panel will indicate"
This shows that the later operated unit(s) is/are not working. In such case, change the remote
control's mode and send the same mode signal which the other indoor unit(s) is/are operating in. The
BEEP will be emitted twice from the indoor unit(s) later operated, and the unit(s) will operate.
Press the MODE button to select the op-
1
eration mode.
Press the ON/OFF button to start opera-
2
2
tion.
5
• The red OPERATION lamp (
will light.
3
Press the THERMO. button to set the de-
3
1
sired temperature.
• In the AUTO and
DRY mode, the tem-
perature
changed
incerments within the
4
range of 2°C higher
to 2°C lower from the
temperature auto-
matically determined
by the air conditioner.
• In the COOL and HEAT modes, the tempera-
ture can be set within the range of 18 to
32°C.
Press the FAN button to set the desired fan
4
speed.
• In the DRY mode, the fan speed is preset to
AUTO and cannot be changed.
To turn off the unit, press the ON/OFF but-
5
ton again.
• The red OPERATION lamp (
will turn off.
" and the OPERATION lamp and TIMER lamp will blink alternately.
E-10
AUTO HEAT COOL DRY
(Example: 1°C higher)
can be
in 1°C
(Example: 2°C lower)
AUTO SOFT LOW
) on the unit
C
C
HIGH
) on the unit