Witter J17U Notice De Montage

MATERIALS
A 1 Cross Bar
B 2 M12 x 35 x 1.75p Bolts
SCP 1 Safety Chain Plate
X 8 Existing Bumper Beam Fasteners
ZE 1 Retractable Electrical Plate
ZN 1 Neck Kit
FITTING
1. Remove Bumper
2. Remove Steel Bumper Beam
3. Fit Cross Bar (A) to the same fixing points as the Steel Bumper Beam by re-using existing Bumper Beam fasteners
4. Assemble the chosen Neck Option (ZN), safety Chain Plate (SCP) and Retractable Electrical Plate (ZE) to Cross Bar
(A) using separate Fitting Instructions from Neck Kit. Note: If fitting a detachable neck, use 2-off fasteners supplied
with the neck and longer fasteners (B) on Safety Chain Plate side.
5. Cut under-tray section of bumper using the diagram below as a guide and refit to vehicle.
Recommended torque settings:
Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200 Nm
Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
Fitting
Instructions
W 0 0 0 1 J 1 7 U - F IT $ 0 1 1 6 0 2 0 1 0 0 0 0
#NAME?
TOWBAR
J17U
For Jaguar XF
2015-