Publicité
Les langues disponibles
Les langues disponibles
FINISH
14
1
WIRED VERSION:
Carry out the following connections:
1 - connect the motor cable to the connection box using the quick fit connector.
2 - Pass the power cable through the cable gland provided and connect the wires
inside the connection box.
Take the two sets of keys out of the bag that contained the notice.
Before closing the lid, insert the key and turn. Make sure that the cables are not
caught between the box and the lid. Press the button closest to the pool. Observe
rotation of the axle, it should turn as though rolling the cover out over the pool (see
the direction of movement on the following page).
If this is not the case, swap the red and blue wires and then try again.
On the "Aquadeck EC" model, add the plus (supplied) to block
the hole usually used to plug in the charger (Aquadeck EB).
15
2
2011/05 - Indice de révision : I - Code : 0035001
24/32
Inversion of the
wires
Publicité
