Publicité
Les langues disponibles
Les langues disponibles
5
Radius in cm L in cm
0
12
15
21
20
26
30
36
Orient the pool with respect to the pool according to the diagram above. The distance of 2cm between the pool wall and
the edge of the stand is approximate. It is more important that the axle is correctly centred across the pool. Make sure that
the leading edge of the axle is positioned vertically over the exit of the the pool corner radius.
Aquadeck covers cannot be installed on pools with a corner radius greater than 30 cm. This is because the axle would
need to be positioned too far forward to allow the end slats on the axle side to pass under the axle and safely cover the
portion of the pool behind the axle.
6
Align the axle with respect to the geometry of the structure. (Measure the diagonals to ensure that the Aquadeck cover is
correctly positioned). If installing the wired version, leave a length of 70 cm of cable.
8
Spirit level
Adjust the hex head screws M6-50 to level the stand. Use
a spirit level to verify the level in both directions (axle and
coping sides)
Rear coping
nose line
Position the axle vertically over
the pool corner radius exit
Approximate distance
between the pool wall and
the edge of the stand
7
9
Screw M6-50
Drill holes Ø10mm though the slots.
22/32
Pool corner radius
2
2011/05 - Indice de révision : I - Code : 0035001
Publicité
