Publicité
Les langues disponibles
Les langues disponibles
PREPARATION BEFORE INSTALLATION
The surface of the coping can be machined to prepare it to receive the roller stands (see above). Alternatively, the stands are
fitted with adjusting screws to adapt to the shape of the coping. The coping nose will need to be trimmed on both sides. The
amount that will need to be trimmed (L in the diagram above), measured from the coping nose of the back wall, will depend on
the overall length of the slat cover (refer to the table below).
Slat cover
Cut-out "L" (in cm)
length
right angle
8 m
29
9 m
30.5
10 m
31
11 m
32.5
12 m
33
13 m
33.5
14 m
35
1
Motor side
Unpack the axle and place it at the edge of the pool on wooden chocks or bubble wrap, etc. Never place the axle directly on the
ground. If installing the solar version of the Aquadeck cover, position the motor on the pool side most oriented towards the south.
In the case of the wired version of the Aquadeck cover, position the motor on the side closest to the power cable.
Position the stands at either end of the axle and slide the solar panel off.
3
Mount the connection box (battery, solar or wired depending on the model) in the stand as shown using two posidriv button head screws
4.8x19.Mount the motor side of the axle on the corresponding stand (battery, solar or wired depending on the model), using the 4 hex
head screws M8-35 (already on the axle), 4 Z8 washers and 4 M8 collar nuts. Repeat this procedure on the bearing side.
Cut-out "L" R15
Cut-out "L" R 20
(in cm)
34.5
36
36.5
38
38.5
39
40.5
ASSEMBLY
21/32
Coping nose
Cut-out
Surface
machining
Cut-out "L" R 25
(in cm)
(in cm)
39.5
44.5
41
46
41.5
45.5
43
48
43.5
48.5
44
49
44.5
50.5
2
4
2011/05 - Indice de révision : I - Code : 0035001
Cut-out "L" R 30
(in cm)
49.5
51
51.5
53
53.5
54
55.5
Publicité
