Scheppach OSM100 Traduction Des Instructions D'origine page 14

Problem
Motor doesn't start
Machine gets slower
during work.
Sanding belt comes off
the drive pulleys.
The wood gets burnt
during sanding.
Strong vibrations
14 english
Trouble shooting
Possible Cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
Too much pressure put on the workpiece.
Belt does not run straight.
a) Sanding disc or belt covered with grease.
b) Excessive pressure on workpiece.
a) loosely mounted tool
b) defective tool
c) spindle knocks
Help
a-d) Replace all damaged parts before you
use your machine again.
e) Contact your local service centre. Every
attempt to carry out a repair, can be danger-
ous if it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a) Replace disc or belt.
b) Reduce pressure on workpiece.
a) tighten tool
b) change tool
c) repair at a Service-Station