Publicité
Les langues disponibles
Les langues disponibles
ARNINNG!: When the AC Power is on, there is a potential of having dangerous voltage at the output terminals on the rear of
the amplifier. Use caution not to touch these contacts. Turn off the AC Mains disconnect switch prior to making any connections.
IMPORTANT!: QSC recommends that you connect jumpers where the terminals are the same points electrically. Refer to
thru
Figure
1. Turn the AC Mains power switch to on. The amplifier starts in the Run mode, or the last mode it was in before power was turned off.
2. Press and release the front-panel power button. The button flashes red, the amplifier is in Mute All mode.
3. Select the configuration appropriate for your loudspeakers, using either Preset Recall, or the Preset Wizard.
The following is a list of configurations for 1-, 2-, 3-, and 4-channel outputs. This is not an exhaustive list, but is intended to give you an idea of what is
available and how the outputs would be wired.
One-Channel Configurations
F9: ABCD
F9: ABCD
EN
1
F8: AB+CD
F8: AB+CD
1 AB+CD
Two-Channel Configurations
F6: A+B C+D
F6: A+B C+D
1 A+B
TD-000368-00-A
22.
ABCD
3 C+D
ABCD Parallel
= Subwoofer
The following are electrically
the same point
A. B, C, and D, (1+)
A, B, C, and D, (1-)
— Figure 14 —
AB in Parallel
Bridged with
CD in Parallel
= Subwoofer
— Figure 15 —
A+B Bridged
C+D Bridged
= Subwoofer
The following are electrically
the same point
X (2+) and Y (1+)
X (2-) and Y (1-)
— Figure 16 —
12
Figure 14
1+
1+
A
B
X
1-
1-
1+
1+
C
D
Y
1-
1-
You can use any, or all of the
connectors A, B, C, and/or D.
1+
A
B
X
1-
C
D
Y
1+
2+
A
B
X
1-
2-
1+
C
D
Y
1-
Optional
Publicité
