Weelko F330 Mode D'emploi page 15

BIO-LIFTING
Instructions of use
1. Connect ones side of the wire in the rear panel, in
the plug named "BIO WAVE MICROCURRENT".
2. Connect the other two sides of the wires in the
handles of BIO-lifting. There are two kinds of handles.
•
The ones that need cotton swabs are used in the
eyes part. Is needed to include two cotton swabs in
the hole of the handle.
•
The ones with only one pole are used to the full
body.
3. Apply enough conductive gel to the treatment area.
4. Make sure that the "ENERGY" level is at the
minimum. You can adjust the output level by pressing
"ENERGY +/-" button.
5. Make sure that the "FREQUENCY" level is adjusted
at 0.1 Hz. You can adjust the frequency level by
pressing "SATE".
6. Select the desired wave state by pressing
"SELECT". There are 4 kinds of waves.
7. Select the time of operating by pressing "TIMER
+/-".
8. Press "START/PAUSE" to start the treatment.
FAQ
Skin scrubber
The probe suddenly stops emitting:
•
If the probe is separated from the skin, it will stop
emitting after 5 seconds. This is a safety feature and
should not be mistaken for a system fault.
•
Touch the skin with the probe and it will start
emitting again after 5 seconds.
Ultrasound
Check the following if the work unit switches on but
the probes do not emit.
•
Put a drop of water on one probe.
•
Switch on the unit and slowly increase the output
energy.
•
If the water starts to move and evaporate, the unit
and the probes are working properly. If not, the probes
are not working properly.
The unit and the probes are working properly but the
customer doesn't feel any e ects.
•
Make sure enough conductive gel has been applied
to the treatment area.