Weelko F330 Mode D'emploi page 14

MAGIC GLOVES
Instructions of use
1. Connect ones side of the wire in the rear panel, in
the plug named "BIO WAVE MICROCURRENT".
2. Connect the other two sides of the wires in each
glove.
3. The beautician must put isolating gloves under the
magic gloves.
3. Select the magic glove function by pressing
"FUNCTION" button.
3. Make sure that the "ENERGY" level is at the
minimum. You can adjust the output level by pressing
"ENERGY +/-".
3. Make sure that the "FREQUENCY" level is adjusted
at 0.1 Hz. You can adjust the frequency level by
pressing "SATE".
3. Select the desired wave state by pressing
"SELECT". There are 4 kinds of waves.
3. Select the time of operating by pressing "TIMER
+/-".
3. Press "START/PAUSE" to start the treatment.
3. The beautician must massage to beautician with the
magic gloves. Adjust the "ENERGY" and "FREQUENCY"
level according to the customer feelings. At this
moment, the beautician don't have to feel any e ect in
their hands, but the customer must feel a micro
current and some warm in the part where the
treatment are applied.
Notes
•
The delivered magic gloves have a length of 20 cm.
The isolating gloves must have a length of at least 23
cm. If there are contact between the beautician's skin
and the magic gloves, there's no e ect with the
treatment.
•
During the treatment, if the beautician breaks the
contact with the customer's skin, the device stops
working suddenly. The device restarts when the
contact between the magic gloves and the customers
skin returns.
Cautions
•
Pacemaker (any electrical or rhythmic
heart-regulating device)
•
Pregnancy
•
Thrombosis/Phlebitis
•
Skin diseases
•
Operations (within the last 6 months)
•
Silicone implants
•
Hypersensitive or vascular skin