Identification; Product Description And Type Designation; Product Markings - Videotec PUNTO Manuel D'instructions

• This device was designed to be permanently
installed on a building or on a suitable structure.
The device must be installed permanently before
any operation.
• When installing the device, comply with all the
national standards.
• Any device which could be installed inside the
product must comply with the current safety
standards.
• For all connections, use cables that are able to
withstand temperatures of at least 75°C (167°F).
• Installation category (also called Overvoltage
Category) specifies the level of mains voltage
surges that the equipment will be subjected to.
The category depends upon the location of the
equipment, and on any external surge protection
provided. Equipment in an industrial environment,
directly connected to major feeders/short branch
circuits, is subjected to Installation Category III. If
this is the case, a reduction to Installation Category
II is required. This can be achieved by use of an
insulating transformer with an earthed screen
between primary and secondary, or by fitting
listed Surge Protective Devices (SPDs) from live
to neutral and from neutral to earth. Listed SPDs
shall be designed for repeated limiting of transient
voltage surges, suitable rated for operating voltage
and designated as follows: Type 2 (Permanently
connected SPDs intended for installation on the
load side of the service equipment overcurrent
device); Nominal Discharge Current (In) 20kA min.
For example: FERRAZ SHAWMUT, STT2240SPG-
CN, STT2BL240SPG-CN rated 120Vac/240Vac,
(In=20kA). Maximum distance between installation
and reduction is 5m.
4
• The product must be fastened with suitable
equipment. The fastening means must guarantee
the mechanical seal when a force equal to at least
4 times the weight of the device is applied.
• Respect the national standards for the connection
of the mains and of the earth conductor during
installation of the device.
• The product is designed to house only cameras
that are properly certified (7W max).
• A disconnecting device, readily and easily
accessible, must be incorporated in the electrical
system of the building for rapid intervention.

4 Identification

4.1 Product description and type
designation
This stylish technopolymer housing has been
designed to accommodate a variety of cameras and
lenses
Very easy to install thanks to the side opening system
that allows the full access to the camera, lenses and
all internal connections.
The front is designed to offer protection from UV rays
and atmospheric agents.
The housing proposes various mounting options,
wall or ceiling brackets, feedthrough and non-
feedthrough, or Pan & Tilt head.
A wide range of accessories for mounting the
equipment is available thereby satisfying all
installation needs.

4.2 Product markings

See the label attached to the product.
MNVCHOT_1511_EN