Signal Info (Information); Signal Adjust - Sony SRX-S110 Manuel D'installation

When the 10-bit signal based on Sony's unique
specification is input, select "10bit Twin Full" or
"10bit Single Full" for a signal of Full Range
compliance, or "10bit Twin Limited" or "10bit Single
Limited" for a signal of Limited Range compliance.
When the LKRI-001 is installed
Select "YPbPr" to input a high-definition signal from
component equipment, and "RGB" to input a high-
definition signal from video GBR equipment.
When the LKRI-003 is installed
For Dual-link input, select "RGB" or "RGB FULL."
For Single-link input, select "YPbPr" or "YPbPr
FULL."
When "RGB" or "YPbPr" is selected, in the case that
a 10-bit HD-SDI signal is input and "Contrast" is set
to 90 in "Signal Adjust" of the PICTURE CONTROL
window, mapping is done so that HD-SDI signal data
values* of 64 to 940 are converted to the video levels
of 0 to 100% to display an image on the projector.
When "RGB FULL" or "YPbPr FULL" is selected, in
the case that a 10-bit HD-SDI signal is input and
"Contrast" is set to 90 in "Signal Adjust" of the
PICTURE CONTROL window, mapping is done so
that HD-SDI signal data values* of 0 to 1023 are
converted to the video levels of 0 to 100% to display
an image on the projector. In this case, inhibition
codes included in a 10-bit HD-SDI signal (data area 0
to 3, and 1020 to 1023) are blocked out.
* Data value 64 of a 10-bit HD-SDI signal input is
equivalent to the video level of 0% (white), and data value
940 equivalent to 100% (black).
I/P Mode: Selects the I/P conversion mode. Depending on
the input signal source, set the mode to "Interlace" or
"PsF."
Notes
• This item is available with the interlace or PsF
signal input.
• When the signal is input from INPUT A or the
LKRI-004 is installed, this item is not available.

Signal Info (Information)

Shows the horizontal and vertical frequencies of the input
signal automatically. The values are approximate.
The type of the input signal is also displayed.
fH: Displays the horizontal frequency.
fV: Displays the vertical frequency.
24
PICTURE CONTROL Window

Signal Adjust

Adjusts the picture quality of the input signal.
Clicking increases the setting value, and
decreases it.
Clicking the RESET button resets all the settings to the
factory preset values.
Contrast: Adjusts the picture contrast. The higher the
setting, the greater the contrast.
Brightness: Adjusts the picture brightness. The higher the
setting, the brighter the picture.
Color: Adjusts the color intensity. The higher the setting,
the greater the intensity.
Sharpness: Adjusts the picture sharpness. The higher the
setting, the sharper the picture. The lower the setting,
the softer the picture.