Connecting The Power - Sony SRX-S110 Manuel D'installation

3
Tighten the two screws firmly with a torque of 0.8±0.1
·
N m.
IN
To remove the input board, loosen the screws fully and
pull it out.
O U T

Connecting the Power

Use an AC power cord that supports 8AWG, 250 V, 40 A
or higher.
Follow the steps below to connect the three-wire power
cord to the AC IN terminal on the left side of the projector.
WARNING
• Connection of the main power and the electric wiring
work should be done by qualified electricians only.
• Do not plug the power cord into the power supply before
completing the following operations.
1
Remove the two screws on the terminal cover and
remove it.
2
Remove the two screws on the cable clamp and
remove it.
3
Pass the AC power cord through the hole beneath the
terminal, and tighten the screw for each wire as
illustrated.
Cable clamp
9
Connecting the Power