Device States - Siemens VersiCharge Manuel D'installation

2.6 Device states

'Power Available' 240 V or 208 V
Power Present,
'Ready to Vehicle detected,
Charge' waiting for
Charging
command
'Charging' Charging Vehicle
'Pause' Operation Paused
'Delay Timer' Operation awaiting
delay timer
'Communications System has
Fault' detected a bad
communications
signal
'Fault' System has
detected a fault
'Remote' System is
controlled via
Auxiliary input
* Halo indicator status when activated. See Section 4.6 for Halo activation
and deactivation
** Ground Fault Only – VersiCharge will automatically attempt to reset after
a ground fault event, unless the system detects a fault immediately upon
entering the 'Charging' state. In this event, a manual reset is required. If
the issue persists, contact a qualified service person for assistance.
© 2012 Siemens Industry, Inc.
Description
'Power Available'
indicator
'Power Available'
indicator,
'Ready' indicator
'Power Available'
indicator, 'Charging'
indicator
'Power Available'
indicator,
'Pause' indicator
'Power Available'
indicator,
'Hour Delay' indicator(s)
'Power Available'
indicator
'Fault' indicator blinking,
'Power Available'
indicator
'Fault' indicator,
'2 Hour Delay'
indicator**
'Power Available'
indicator, 'Remote'
indicator
- 11 -
Indicators
Off
Green –
Solid
Green –
Fading in
and out
Off
Off
Red –
Blinking
Red – Solid
Off
Document Number: 813540
Halo
Indicator
Status*