Siemens VersiCharge Manuel D'installation page 112

Siemens VersiCharge™
Important Safety Information
Read the enclosed Installation and Operations Manual in its
entirety prior to installing, maintaining, servicing or replacing a
Siemens VersiCharge Electric Vehicle Charging System.
Because of the inherent dangers of electricity, only a qualified
person should install, maintain, service or replace electrical
wiring and connected equipment. For the purpose of this
manual, a qualified person is one who is familiar with the
FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Tools required for installation:
# 2 phillips screw driver or bit
•
#1 flat head screw driver or bit
•
#2 flat head screw driver or bit
•
7/16" socket head (with drill attachment)
•
electric drill
•
3/32" allen wrench or hex bit
•
torque wrench
•
adjustable wrench or pliers (optional)
•
Siemens Industry, Inc.
5400 Triangle Parkway
Norcross, GA 30092
1-800-241-4453
Info.us@siemens.com
www.usa.siemens.com/VersiCharge
© 2012 Siemens Industry, Inc.
installation, construction of operation of the equipment and the
hazards involved. In addition, this person should meet the
definition of qualified person pursuant to NEC®. Use of proper
personal protection equipment, including, but not limited to, eye
protection, shock protection, gloves, and other appropriate
protection, is recommended when installing or servicing any
electrical equipment.
- 111 -
Document Number: 813540