Halo Operation - Siemens VersiCharge Manuel D'installation

• From either the 'Charging' state or the 'Ready to Charge' state, press
the 'Delay Timer' button
• Pressing the button once, will delay charging for 2 hours
• Pressing the button twice, will delay charging for 4 hours
• Pressing the button three times, will delay charging for 6 hours
• Pressing the button four times, will delay charging for 8 hours
• Pressing the button a fifth time will deactivate the timer and return
the VersiCharge to the 'Ready to Charge' state, and if the vehicle
requires a charge, to the 'Charging' state.
• Every two hours, the next 'Hour Delay' indicator will turn off, so a user
can tell how much delay is remaining by looking at the remaining
illuminated 'Hour Delay' indicators.
• For example: If only the '2 Hour Delay' indicator is illuminated, the
delay is less than 2 hours remaining.
• When the delay timer runs out, the VersiCharge will automatically
return to the 'Ready to Charge' state, and if the vehicle requires a
charge, to the 'Charging' state.

4.6 Halo Operation

The halo indicator can be deactivated. This will prevent the halo from
illuminating in all states, except the 'Fault' state.
• Remove the connector from the vehicle and place in the connector
holster
© 2012 Siemens Industry, Inc. Document Number: 813540
- 28 -