Operating Instructions; Moving Jaws Adjustment - Sicam COLIBRI BL512 Notice Originale

en 28 | COLIBRI BL512 26" ITAS | Operating instructions
5.

Operating instructions

Warning - tire or rim damage danger!
Excessive pressure can e. g. result in cracks
(on the inside/outside) of the tire. The rim
can be scratched or deformed.
€
Read the Wdk publications available in
German and English! (www.wdk.de: moun-
ting/demounting instructions – criteria
catalogue)
€
Inner temperature of the tire must be at
least 15 °C (only in case of RFT/UHP).
€
Read the Wdk publications available
in German and English! (www.wdk.de:
mounting/demounting instructions – tire
overheating)
€
Adjust pressure to the type of tire.
€
Use the plastic protections on the types of
rim that need it.
!
Before demounting or mounting operations it is ext-
remely important to collect all the rim and tire data.
In this way it will be possible to know in advance the
mounting, the pressure and the required accesso-
ries!
i
Remove all the balancing weights from the rim.
i
If the semi drop centre of the rim is placed in the
inside part it is necessary to insert a cover to the
locking jaws (see chap. 3.3) on the flanged plate,
because in this case the rim leans on its side during
rotation.
|
105 890 2010-11-08
5.1

Moving jaws adjustment

To work on wheels up to 26'', it is possible to adjust the
position of the 4 moving jaws as shown in pic.3.
+
For the adjustment from 20" to 24" it is enough to
press the double pin and move backwards manually
its upper part.
+
For the 26" adjustment, once the 24'' size has been
reached, remove the "R" shaped split pin that locks
the double pin, take off the double pin, put it into
the two rear holes and insert again the "R" shaped
split pin, then make the moving part slide until the
26'' position is reached.
20''
1
2
3
24''
26''
Fig. 3: Moving jaws adjustment
22''
Sicam srl società unipersonale