Tire Mounting; Mounting Preparations - Sicam COLIBRI BL512 Notice Originale

en 30 | COLIBRI BL512 26" ITAS | Operating instructions
i
In case RFT or UPH tires the use of accessories like
clamps, wedge or of the TECNOROLLER SWING
bead breaker is suggested.
8. With the provided bead breaking lever lift the edge
of the tire and lean it on the mounting tool tab (1).
9. Press the rotation pedal to rotate clockwise the lo-
cking plate, until complete ejection of the bead from
the rim.
i
In case of tires with tube, use the locking knob to
unlock the horizontal arm and move it to free the
working area and extract the tube.
10. Repeat the same operations to make the second
bead come out.
|
105 890 2010-11-08
5.3
1
5.3.1
1. Lubricate with mounting paste the inside of the rim
in correspondence of the edge and of the shoulder
of the rim and of the semi drop centre.
2. Lubricate the two tire beads with mounting paste.
3. Lean the tire oblique on the rim.

Tire mounting

Danger of car accidents caused by damaged
rims or tires!
In case of tire or rim damage during moun-
ting dangerous or even lethal situations may
occur during driving.
€
The operator has to be specifically trained.
€
Do not exert excessive forces on the tire or
the rim, adjust the slow rotation speed.
€
Use a sufficient quantity of mounting
paste.
€
In case of anomalies, e.g. suspicious noi-
ses, stop mounting immediately.
€
For mounting of critical rim/tire combina-
tions, read the Wdk publications available
in German and English!(www.wdk.de:
mounting/demounting instructions – crite-
ria catalogue).

Mounting preparations

Warning – damage risk for RFT or UHP tires!
Cracks in case of operation on cold tire. Tire
explosion in case of high speed.
€
Inner temperature of the tire must be at
least 15 °C.
€
Read the Wdk publications available in Ger-
man and English! (www.wdk.de: mounting/
demounting instructions – tire overheating)
€
Before mounting put the tire in a temperate
room.
Sicam srl società unipersonale