Charging The Internal Battery - SilverCrest SNL 15 B1 Mode D'emploi Et Consignes De Sécurité

Charging the internal battery

CAUTION
► Charge the speaker only in dry interior rooms.
► Due to the high power consumption, the speaker must be charged
using a USB mains adapter. Do not charge the speaker from the
USB port of a PC or notebook.
► Use only a USB mains adapter with an output voltage of 5 V and
an output current of at least 1 A to charge the speaker.
Use only the supplied charging cable q to charge the speaker!
►
Always disconnect the charging cable q when charging is
►
complete and close the protective cover 4!
Before using the speaker, the integrated battery must be completely
charged.
Open the protective cover 4.
♦
Connect the USB type-A connector of the charger cable q to a
♦
suitable USB mains adapter (not supplied).
Connect the micro-USB plug of the charging cable q to the
♦
micro-USB charging socket 3 on the speaker.
When charging is complete, remove the charging cable q from
♦
the speaker and close the protective cover 4.
NOTE
The charging LED 2 lights up orange during the charging process.
►
When the battery is fully charged, the charging LED 2 goes out.
► When the battery is fully charged, you can play back music for
around 10 hours at a medium volume. The playback time may
vary depending on usage.
► When the battery charge is low, you will hear a beep. The
charging LED 2 flashes orange every 10 seconds. When the
battery is exhausted, the speaker turns off automatically. You will
hear a beep and the charging LED 2 goes out. If the battery is
completely exhausted, it will take about 3 hours to fully recharge
the battery.
► The speaker cannot be used during charging.
SNL 15 B1
GB │ IE │
29 ■