Technical Information - Atag VA6311SF Notice D'utilisation

26
Problem
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
Activating the rinse aid dispenser
with the multitab function activated
1. Press the on/off button to activate the
2. Press and hold function buttons (B) and
3. Press function button (B) .
4. Press function button (B) to change the
5. Deactivate the appliance to confirm the
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Possible solution
rinse aid together with the combi deter-
gent tablets.
Refer to 'HINTS AND TIPS' for other
possible causes.
appliance. Make sure that the appliance
is in setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
(C) at the same time until the indicators
above function buttons (A), (B) and (C)
start to flash.
• The indicators above function buttons
(A) and (C) go off.
• The indicator above function button
(B) continues to flash.
• The display shows the current setting
of the rinse aid dispenser.
setting.
setting.
2)
Off
On
596 / 818 - 898 / 575
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12