Technical Information - Atag VA6111MT Notice D'utilisation

26
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
If the washing and drying results are
not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water
supply to decrease energy consumption.
Activating the rinse aid dispenser with
the multitab option activated
1. Press the on/off button to activate the
2. Press and hold function buttons (B) and
3. Press function button (B).
4. Press function button (B) to change the
5. Deactivate the appliance to confirm.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
activate the rinse aid dispenser and use
rinse aid together with the combi deter-
gent tablets.
Refer to 'HINTS AND TIPS' for other
possible causes.
appliance. Make sure that the appliance
is in setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
(C) at the same time until the indicators
of function buttons (A), (B) and (C) flash.
• The indicators of function buttons (A)
and (C) go off.
• The indicator of function button (B)
continues to flash.
• The display shows the setting of the
rinse aid dispenser.
setting.
2)
Off
On
596 / 818 - 898 / 555
220 - 240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12
1.90 W
0.10 W