DO421K
Note: the appliance will automatically switch off after 2 hours.
MAKING COFFEE USING PRE-GROUND COFFEE BEANS
CAUTION: Always take the coffee jug out of the appliance first. Otherwise, the jug
might fall out of the appliance when you open the filter.
Open the water reservoir and fill it up with the desired amount of water. Make sure not
to fill above the maximum (=10) water level.
Close the lid of the water reservoir.
Open the filter compartment and install a filter in the filter retainer.
Fill up the filter with the desired amount of ground coffee.
Close the filter compartment.
Press the "brew" button to activate the brewing process. The indication light will light
up.
Note: when the brewing process has been completed, the "cup" symbol on the display
will start to flash.
Press the "brew" button again to switch off the coffee-maker. The indication light will
switch off.
MAKING COFFEE USING THE TIMER
Note: before you can use the timer, you first have to set the right time, as described
earlier in this manual.
Press and hold the "auto/prog" button until the display starts to flash.
You can now set the desired starting time for the brewing process using the "H" and
"M" buttons.
When you are making coffee using freshly ground coffee, first select the standard
coffee strength and fine tune it. If you are making coffee with pre-ground coffee, press
the "brew" button.
Wait for a couple of seconds until the indication light switches off. Then press the
"auto/prog" button again. The indication light will light up again. When the set time is
reached, the appliance will switch on automatically.
STOPPING THE BREWING PROCESS
To stop the brewing process, press "on/off".
MAINTENANCE AND CLEANING
Warning: danger of burning. Pull the plug from the mains socket and allow the
appliance to cool down completely before cleaning.
Danger: danger of electrocution. Never immerse the appliance in water or another
liquid.
Caution: danger of damage. Never use aggressive, abrasive or chemical cleaning
35