THOMSON WKT173GD Guide D'installation Et D'utilisation page 29

Electrical connection
For your own safety, you must
comply with the instructions
given below.
The electrical installation must com-
ply with Standard NF C *15-100, in
particular concerning the earth.
Three-core flex 3x2.5 mm², 230V
connected to:
- a 20A supply 230V-50Hz
- an ELCB and an individual fuse (10
or 16A depending on the model)
- a 16/20A socket with two poles
+ earthed socket
We cannot be held responsible for
any incident caused by a faulty
electrical installation.
Recommendations for the elec-
trical installation of your appliance:
- Do not use extension leads,
adaptors, or socket boards.
- Always make sure your circuit is
earthed.
- If you have to change the supply
lead, we recommend that you
exchange it for a lead of the same
type. You can get this from our
after-sales service
Your appliance is compliant with European Directives
CEE/73/23 (low voltage directive), CEE/89/336 (electromagnetic
compatibility) and CEE/96/57 (energy efficiency) as well as
their modifications.
- The socket must always remain
accessible, yet be out of the reach
of children.
If you have any doubts, contact
your installer.
Carry out the initial cleaning
(See section on "Installation of
your appliance ") before connec-
ting your appliance to the electri-
cal supply.
Disconnect your appliance prior to
carrying out any maintenance ope-
ration. Grasp the plug directly,
rather than pulling on the electric
lead.
GB
29