Publicité
Les langues disponibles
Les langues disponibles
5- Fit the plinth end into the space
provided for the hinge bracket.
6- Screw the plinth on.
7- Reposition the door on the lower
hinge pin, put the upper hinge in
place and screw on.
Reversing the door handle
1 Use a screwdriver to remove the two
screw covers. Remove the screws and
block the holes with the plugs supplied
with these instructions.
2. Identify, and then use the handle
to mark, the positioning of the holes
to be drilled on the door.
3 Using an electric drill, make two
3,4 mm holes.
4 Refit the handle with the two
screws, and replace the screw
covers.
Adjusting the door
If necessary, you can adjust the align-
ment of the door and the wine cellar
control panel.
Proceed in the following manner:
1- Open the door so that it does not
impede your view.
2- Whilst holding the door, unscrew
the securing screw from the upper
hinge.
How to carry out your initial installation
7
3- Remove both hinge and door.
4- Use a sharp tool to cut the stop
from the hinge bracket.
5- Refit the door and the hinge.
6- Screw the hinge securing screw
back into place, fairly tightly.
7- Close the door and align it with the
control panel.
GB
410 mmm
27
Publicité
