Publicité
Les langues disponibles
Les langues disponibles
GB
Installation – Where to locate
• Look for a suitable place (near a socket, for the mains adapter). Optimal function is at a height of 2 m and
pointed downwards at an angle of approx 15°.
• Locate the unit at a place where most of the movements are transverse to the PIR. These movements can
be detected more quickly than movements towards the PIR (Fig. 5 + 6).
• Fix the mounting device to the wall, using one or two screws. Then slide the alarm unit onto it (Fig. 3).
If necessary, tighten the socket joint with the adjusting screw.
• If you need to drill a hole in the wall, check the wall for concealed electric cables.
• The alarm unit can also be placed on a shelf or hung on a screw head or wall hook.
• The PIR reacts to changes in temperature. Do not place the unit near heaters or ventilating shafts (and not
directed towards there). The intruder alarm will also react to animals and cars !
Figure 4
PIR-detection range
Operation (Figure 7)
When plugging the mains adapter or inserting new batteries, the unit is in stand-by mode or switched off. The mi-
ni alarm is operated by pressing the remote control (turn the transmit window towards the alarm unit). The remote
control has a range of approx. 6m at an angle of 30°.
By pressing the remote control once, the unit is switched on – the green LED will shine and the unit will sound a
beep. You may now leave the covered area within 30 seconds. After 30 seconds, the unit is
armed. The green LED will go off, and the red LED will flash.
If a person or any other warm object moves within the covered area, the unit will switch to the detection mode. It
can be switched off by pressing the button on the remote control within 15 seconds. Otherwise the unit will switch
to the alarm mode.
The alarm siren can be turned off with the remote control. Otherwise the siren will stop automatically after 45 se-
conds. The unit will stay in the armed mode and can trigger a new alarm.
Replace the batteries if the siren becomes quieter or if the LEDs flash irregularly or they become dim or if the re-
mote control does not operate correctly.
Troubleshoooting
The device does not work.
The device only works partially.
Reduced range of the PIR- sensor.
unreliable or unwanted detection
Unit activates without any obvious reason
6 m
Figure 5
sensitive
✔
Check the condition of the batteries and the
connecting for mains adapter.
Allow for detection and delay periods
Is the recommended height of 1,5 m observed?
Is the location too warm?
Change the postion. (see "Where to locate")
Is the location too warm?
this may be a sign that the batteries have
reached the end of their lives.
✘
Figure. 6
less sensitive
Publicité
