Trouble Shooting - FLORABEST FRM 1200 C3 Traduction Du Mode D'emploi D'origine

Trouble Shooting

Problem
Equipment does not
start
Motor stops
Result unsatisfactory or
motor labours
Blade fails to turn
Strange noises, rattling
or vibrations
Possible Cause
Power is off
Defective on/off switch
A
( 12)
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign
object
Cut height too low
Blade ( 18) blunt
I
Blade area blocked
Blade assembled
incorrectly
Blade blocked by grass
I
Blade screw ( 17)loose
I
Blade screw ( 17)
loose
Blade damaged
Fault Fixing
Check the socket, cable,
wire and plug and have
any repairs carried out
by an electrician
Repair by customer
services
Set a greater cut height.
Lift the front wheels
slightly by pressing down
on the handle bar (1).
Remove the foreign
object
Set a higher cut height
Have the blade
sharpened or replace it
Clean the equipment
Install the blade correctly
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade
GB
39