Description Of The Front And Back Panels; Mains Socket - Comeg SYMBIOZ Cam+ Manuel Utilisateur

7 Description of the front
and back panels

7.1 Mains socket

The camera receives electrical power by means of the mains plug located on the back panel
must be connected to the mains power supply by the lead supplied with the camera. This plug carries a
fuse trap as well as a master switch for turning on the apparatus.
The camera uses T1AL - 250V fuses.
When replacing a fuse, the camera must be unplugged and the same type of fuse must be used.
The "T" in "T1A" means "time-delay". Only use fuses marked UL/CSA.
7.2 Video output ports
The following video output ports are available on this camera: DVI
Y/C C10 and composite
The DVI output port provides the best image quality in 1080p format over short distances.
HD-SDI, 3G-SDI output ports are used to transport the video signal over long distances
(screen at a distance of up to 50 m).
7.3 Peripheral output ports
Two (2) peripheral output ports are available
two peripherals (for example: a printer and a video recorder) from the buttons on the camera head.
The apparatuses connecting to the "VIDEO OUT" and "PERIPHERAL" ports must be
compliant with standard IEC 60950.
7.4 Keys and symbols on the front and back panels
The keys and symbols on the back panel are for identifying the camera in accordance with
inter- national standards IEC 60601-1, IEC 60601-2-18, IEC 60417 and EN 980.
22
C11 .
C12 and these are used with a 3.5 mm jack lead for managing
C6 C8
, HD-SDI, 3G-SDI , RGBS
C2 , which
C5
,