SUOMY apex Instructions D'utilisation page 32

ENG
USER'S INSTRUCTIONS
After fitting the parts verify that the mechanisms are positioned correctly and tightly fixed to the shell. Then fit the visor and adjust
as indicated in the above paragraphs.
After fitting the mechanism verify that the visor is tightly fixed to the helmet, that it rotates freely and that it locks correctly into the
locking positions.
If this doesn't happen and the rotation mechanism of the visor doesn't work correctly, do not use the helmet and contact authorized
Suomy personnel only.
NOSE GUARD see figure 12
Removing guard
The nose guard is clicks into position between the shell and the internal lining of the chin guard. To remove it just pull (X) upwards. Carefully
remove the nose guard.
Fitting the guard
Position the nose guard centring it on the visor's opening, inserting the tabs (A) between the shell and the chin guard lining. Press firmly on the
nose guard near the tabs (A) until the lower edge of the nose guard is completely fitted on to the edge of the shell.
If these conditions are not verified and the nose guard does not
adhere to the edge of the shell or is not correctly positioned, do
not use the helmet and exclusively contact authorized Suomy per-
sonnel.
figure 12
30