SUOMY apex Instructions D'utilisation page 28

ENG
USER'S INSTRUCTIONS
Assembly
Verify that the locking lever (A) is completely tilted up.
Inset (X) the strap (B) in the hole (C) inside the cheek pad.
Fix the back part of the cheek pad to the fixed part of the internal lining. Verify that the fastening
tab (D) is correctly inserted in the specific seat (E).
Push the cheek pad towards the back part of the helmet and at the same time rotate it until it is
completely in its seat against the chin guard (F).
Rotate (Y) the locking lever (A) downwards and push it against the lining until it clicks into
position.
Verify that the part was assembled correctly by checking that:
- the cheek pad is firmly locked in position
- that the strap is completely free inside the hole and was not blocked under the cheek pad
during assembly.
Only the correct assembly of the cheek pad and the correct positioning of the strap will
assure the proper operation of the retention system. While using the helmet the lock lever
must always be locked into position. If it can't be locked correctly do not use the helmet.
CHEEK PADS
Removal
The lining is fitted to the polystyrene support without using adhesives or mechanical fastening
systems. To remove it just slide it out of the support opening the elastic closing edge on the
back part.
Fitting the part
Insert the lining on the padding starting from one side and then fitting it onto the opposite. Verify
that the lining is correctly fitted to the padding, so that it is pulled tight with no folds.
26
see figure 7
Removing the fabric lining
C
X
B
F
E
A
Y
figure 7
D