SUOMY apex Instructions D'utilisation page 30

ENG
USER'S INSTRUCTIONS
Fitting the visor
To assure the proper operation of the rotation system of the visor, before fitting the visor back on, verify that all the parts (pins and
seats on helmet, fastening rings and relating accessories, visor surface in contact with the moving parts) are perfectly clean.
The fastening ring nuts must be fitted following the application direction indicated by a letter on the moving back part (L: left side
with helmet on – R: right side with helmet on).
With plastic tab lifted up, position the visor on the mechanism so that the tabs (A) and the visor rotation hole (B), are correctly inserted in the
visor rotation mechanism seat (C). Insert (X) the seats of the rotation hole (B) on the visor in the rotation mechanism. Verify that all the visor
tabs are correctly inserted in the mechanism and only after rotating (clockwise - Y) the plastic lever into locking position.
When the visor is completely closed, reinsert (Z) the cover (D) paying attention to insert the upper tab (E) in its seat (F). After inserting it
slightly press the cover kit until it clicks. Now the cover kit is correctly inserted.
Repeat the operation on the opposite side.
After completing this operation verify that the visor is tightly fixed to the helmet, that it rotates freely and that it locks correctly into the locking
positions.
If this doesn't happen and the rotation mechanism of the visor doesn't work correctly, do not use the helmet and contact authorized
Suomy personnel only.
Adjustment
If, after replacing or using the helmet for a long period of time, there should be leaking from the edges of the visor when it is completely closed,
it might be necessary to adjust the visor's operation mechanism.
Lift the visor until it is completely opened.
Remove the cover kits, as specified in the previous paragraph, leaving the visor on the helmet.
Loosen the upper screw (G) and the lower screw (H) without removing them and without removing the mechanism.
Lower the visor to the closing position and keep it inserted in the mechanism during the rotation.
When the visor is lowered and blocked in closing position, press on the front part and then on the sides, so that the rubber gasket on the shell
completely adheres to the visor for its entire length.
Fasten the lower screw (H) and upper (G) on one side. Re-check the position and fasten both screws on the opposite side.
Reposition the cover kits as specified in the previous paragraphs.
28
see figure 10
see figure 10