Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 6: Assembling the computer
1
14
54
2
STEP 6
Connect the upper computer cable (14) and the hand pulse cable (54) with the computer (1).
Then attach the computer (1) to the handle bar (57) with four screws (2).
Step 7:
Make sure all parts are attached correctly and fully tighten all bolts, nuts and screws.
MAINTENANCE AND USE
This device requires a regular check-up to prevent physical injury. This means that bolts and nuts
should be frequently checked for cracks and sharp edges etc.
Defective components must be replaced immediately. If this is not possible, the device must be
put out of order until the necessary repairs have been made.
Clean only with a damp cloth, do not use solvent cleaners.
This product is intended for use in clean, dry conditions. You should avoid storage in excessively
cold or damp places as this may lead to corrosion and other related problems.
COMPUTER COMMANDS
Placing or replacing the batteries.
Attention: when removing the batteries, all the data saved in the computer will be deleted.
Open the battery compartment at the back of the computer.
Place two AAA-batteries in the battery compartment.
Publicité
Table des Matières
