Monacor International JTS MH-8800G/5 Mode D'emploi page 8

Dynamic Wireless Microphone
These instructions are intended for users without
any specific technical knowledge Please read
these instructions carefully prior to operation
and keep them for later reference All operat-
ing elements and connections described can be
found on the fold-out page 3
1 Overview
1 Microphone cartridge
2 Battery status indication
3 Indication of the transmission group and
the transmission channel (fig 4, page 10)
4 Key
to scan the transmission group /
channel in descending order (in the group
adjusting mode / channel adjusting mode), to
decrease the sensitivity (in the sensitivity ad-
justing mode), and to deactivate the locking
function (in the lock adjusting mode)
5 Key to scan the transmission group /
channel in ascending order (in the group
adjusting mode / channel adjusting mode),
to increase the sensitivity (in the sensitivity
adjusting mode), and to activate the locking
function (in the lock ad justing mode)
6 Key SET
with the microphone not locked:
to call up and to exit the adjusting modes for
transmission group / channel, sensitivity, lock-
ing function
with the microphone locked:
to call up and to exit the adjusting mode for
the locking function
7 Cap for the battery compartment; to insert
or to replace the batteries (2 × 1 5 V batteries
of size AA), unscrew the cap
8 Identification ring; can be replaced by one
of the colour-coded rings supplied
9 POWER switch
10 Safety cap to cover the switch to be pro-
tected against accidental readjustment
11 Mute switch for short muting ("throat
clearing mode" or "enquiry mode") with
8
chapters 5 1, 5 2 and 5 3 1
☞
chapter 5 3 2
☞
subsequent immediate readiness for opera-
tion without delay
12 4-pole contact, each on the microphone car-
tridge (fig 2) and on the handle (fig 3);
prior to assembling the microphone car-
tridge and the handle, connect the contacts
with each other
2 Important Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The microphone is suitable for indoor use
only Protect it against dripping water, splash
water, high air humidity and heat (admissible
ambient temperature range 0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never
use chemicals or water
•
No guarantee claims for the microphone and
no liability for any resulting personal damage
or material damage will be accepted if the
microphone is used for other purposes than
originally intended, if it is not correctly oper-
ated or if it is not repaired in an expert way
If the microphone is to be put out of
operation definitively, take it to a local
recycling plant for a disposal which is
not harmful to the environment
3 Applications
In combination with the multifrequency receiver
US-903DCPRO / 5 from JTS, this dynamic hand-
held microphone with integrated multifrequency
transmitter creates a wireless audio transmission
system The wireless microphone operates with
four transmission groups (A – D) to which 16
transmission channels are assigned, i e alto-
gether 64 factory-set transmission channels are
available These channels in the UHF range of
518 – 542 MHz can be selected as desired
The microphone is equipped with a micro-
phone case, a microphone holder and coloured
push-on plas tic rings for identification of the
microphone