SilverCrest SRR 3.7 B2 Mode D'emploi page 41

5) Replace the cutting unit
Insert the 3 shaving heads in the recesses of the cutting
–
unit
heads rest on the catches in the opening.
Place the round blades into the shaving heads.
–
Replace the shaving head holder, press it down a little and
–
slightly turn the gear wheel clockwise.
NOTE
If the holder for the shaving heads cannot be reat-
tached, it may be that the gear wheel is a little skew.
In this case, turn the gear wheel anticlockwise again
up to the stop. The holder for the shaving heads can
then be fitted.
The cutting unit
6) Remove loose hairs from the shaver with the brush
7) Replace the cutting unit
into place and is seated firmly.
■ Clean the housing with a moist cloth.
SRR 3.7 B2
. Ensure that the notches on the edge of the shaving
is now installed again.
. Refer to figure 1 for assistance:
on the shaver. Ensure that it snaps
.
GB │ IE │
37 ■