Fitting The Suspended Power Distributor; Installation Preparation; Connecting The Device - Mennekes AMAXX Notice D'utilisation Et De Montage

5.3 Fitting the suspended power distributor

5.3.1 Installation preparation

The receptacle combination has a chain (1) so that it can be
attached to a suspension fixture.
Receptacle combination as a suspended power distributor
Caution
Risk of sustaining injury due to the device falling
down
If the load is too much, the device may fall down and
cause injury.
• Avoid attaching additional weight to the device.
• Do not suspend yourself from the device.
Material damage due to unsuitable mounting
If the device has not been properly mounted, it may fall
down and sustain damage.
• With due consideration to the weight of the device, use
• Bear in mind the weight of the device
Ö
1
• Use the chain to secure the receptacle combination on the
suspension fixture intended for this purpose.

5.3.2 Connecting the device

The suspended power distributor is connected to the power
supply in the same manner as the wall-mounted power
distributor.
• Install the supply line for the device without attaching a
mechanical load (e.g. device weight).
• Connect the device to the power supply.
Ö
Attention
a suitable suspension fixture that is capable of carrying
the weight.
see Rating plate
see page 12
DE
EN
NL
FR
IT
15