Mennekes AMAXX Notice D'utilisation Et De Montage page 37

Opening the device
• Slightly pull the housing cover (1) to the front and swing it
open.
Laying and connecting the supply line
2
Pull out the mounting rails
• Push both locking levers (1) towards the inside (a) and pull
forward the mounting rails (2) with the fitted components
(b).
• Proceed with the remaining mounting rails in the same
manner.
1
2
1
a
b
1
Connecting the device
• Remove the jacket of the supply line so that the required
length is reached.
• Guide the supply line (1) through the cable gland (2) into
the housing.
• Guide the supply line behind the fitted components (3)
until the required length has been reached.
• Tighten the cable gland (2).
• Push the mounting rails back into the housing so that they
lock in place.
• Remove the insulation from the individual wires.
• Connect the wires to the accordingly marked terminals.
• Check to ensure that all wire terminations and pre-wired
components in the device are firmly fitted.
• Tighten loose threaded connections as needed.
2
DE
3
EN
NL
FR
IT
13